Stjarnagloss Snö X lntensive Snow Foam Pre-Wash

Stjarnagloss Snö X lntensive Snow Foam Pre-WashNEW Hyper Strength Sn X Intensive Pre Cleaning Snow Foam You asked (a lot): Can you mix Frst and Sn?Now you canand without buying two separate products. Sn X Hyper Strength Snow Foam combines the heavy duty cleaning power of Frst with the thick, long dwell time of Sn, creating an intense pre wash snow foam designed to tackle serious grime fast. It delivers deep cleaning, excellent cling, and a satisfying, luxuriant foam blanket that helps carry dirt

NEW Hyper Strength Snö X – Intensive Pre-Cleaning Snow Foam

You asked (a lot): “Can you mix Först and Snö?”
Now you can—and without buying two separate products.

Snö X Hyper Strength Snow Foam combines the heavy-duty cleaning power of Först with the thick, long dwell time of Snö, creating an intense pre-wash snow foam designed to tackle serious grime fast. It delivers deep cleaning, excellent cling, and a satisfying, luxuriant foam blanket that helps carry dirt safely away before contact washing.

This is a high-strength, non–pH-neutral snow foam, aimed squarely at enthusiasts and professionals who want maximum pre-cleaning performance.

Why Choose Snö X – Hyper Strength Snow Foam?

Först-Level Cleaning Power
Packed with strong surfactants and active cleaners to break down heavy traffic film, winter grime, and road contamination with ease.

Thick Foam, Extended Dwell Time
Produces a dense, clinging foam that stays on the surface longer—especially on lower panels where dirt builds up most.

Two Products in One
Delivers the cleaning strength of Först with the foam performance of Snö, saving money and simplifying your wash routine.

Highly Economical
A single litre of concentrate provides approximately 20–40 pre-washes, depending on dilution and usage.

For post-wash protection and beading, pair Snö X with Glö Hydrophobic Snow Foam.

Important Information

⚠️ Snö X is NOT pH-neutral
This product is significantly stronger than regular Snö and should be used with care:

• Never allow the foam to dry on the vehicle

• Use caution on sensitive finishes

• Avoid extended dwell time on plastic and metal trim

• If unsure, use regular Snö, which is the safer option

How to Use Snö X

Application
Apply via a professional snow foam cannon using a pressure washer rated at 130 bar or higher for best results.
Recommended dilution: 50–100ml per 1 litre of water.
Lower-powered washers may require a stronger mix.

Coverage
Apply from the bottom upwards to maximise dwell time on the dirtiest lower panels.

Dwell & Rinse
Allow the foam to dwell briefly, then rinse thoroughly with clean water.
Do not allow the product to dry on the surface.

Mixing Guide

1 Litre Bottle

• Dose: 50–100ml per fill

• Produces 20+ litres of snow foam solution

• Enough for approximately 30–40 car washes